How to install quick change Rocket Sprockets

#1 Loosen the retaining nuts ½ to 1 full turn

#2 lift and rotate sprocket half’s counter clockwise off the hub

#3 Position new sprocket using the half hole of each sprocket half

#4 Lower and rotate halves clockwise onto the sprocket hub studs

#5 Retighten the retaining nuts
No need to remove the nuts from the studs or total removal of the gears guards which saves time when making important gear changes these sprockets can
Also be mounted using the conventional six bolt hole pattern.
Please avoid recreational twisting This design is made to simply snap over the axel for quick and easy installation
How to install the twist series sprocket

#1 Lay the sprocket flat against the axel with logo and number facing you.

#2 The twist split line is now parallel to the axel snap the top half over the axel this method greatly reduces the flex and distortion of the sprocket

for best alignment wrap chain around the sprocket and pinch tight to seat chain rollers into sprocket

rocket2024010009.jpg rocket2024010008.jpg
Sprocket Demo
Made in America with pride
rocket2024010004.gif rocket2024010003.gif rocket2024010002.gif
{Copyright (C) 2012 Avanquest Software, Inc. All Rights Reserved}